Adam Sub12 Manuel de service télécharger pdf (Page 9)

Sub12 Manual / english

On the front side you will ﬁnd Indicator LEDs for the operating and standby

modes. Controls for the satellite ﬁlter, phase switch, signal on/continous

mode and Sub Level/Filter are located on the rear panel of the subwoofer.

The following tips are intended to assist you at using the controls in the best

manner.

5.1 LEDs

There are two LEDs on the front indicating either

operating or standby mode. In case the subwoofer

receives an overload the lower LED will ﬂash red

indicating the function of the protective circuit.

5.2 Controls on the rear panel

a) Mode

This push button allows you to choose between

• Signal On: woofer starts operation as soon as a

musical signal arrives, and stops after 15 minutes

without a signal.

• Continuous: the unit is permanently working.

We recommend the ”Signal on” position. It

minimises power consumption and makes handling

very easy.

b) Subwoofer Phase

With the Phase Switch you can alter the phase of the subwoofer

relative to the satellites. That means to change the polarity of the bass

unit. Depending on the distance between woofer and satellites, either

0° or 180° may be the better position. We recommend to try out what

position sounds better within your system.

5. Controls

Standby - Protect

Sub12

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

Pas de commentaire

Adam Sub12 Manuel de service Page 9